|
|
|
|
Original Message
|
| RE: high riser intake |
| By Mike McQuesten - 02/07/2002 3:41:36 PM; IP 206.193.0.124 |
You had the heads cut "some"? How much is "some"? You can't just guess how much you're milling off a set of heads and then attempt to bolt on an FE intake. There's a specific formula for doing this.
You can just use a quality silicone to replace the cork seals if you want. Many and probably most do now. Even Edelbrock recommends this procedure in their directions with their intakes. But it's not the end seals that are causing your high riser intake to not line up properly. I don't think it's that anyway.
If you had the heads milled(were they High Risers?! - who told you to do that?)then you are going to have to mill that high riser intake which relegates it to nearly Zero $ value. But hey, it's yours. If you want to cut it up and paint 'er purple, go ahead.
Milling High Riser Heads and a HR intake.....I'm about to gag on my sandwich. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|