|
|
|
|
Original Message
|
| All FE cranks have the same flange pattern. |
| By Dave Shoe - 02/08/2002 1:42:28 AM; IP 216.243.158.75 |
Per Ford blueprints: The FE and FT crank flange pattern is a 4.25" bolt circle with six holes threaded 7/16-20 UNF 2B. The holes are equally spaced, except one hole (when looking at the flange from the rear of the car, it's the third hole clockwise from the square notch) is offset 0.10".
When the square notch on the flange is pointed straight down, cylinder 1 is at TDC.
Shoe. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|