Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

The area behind bearing is the biggest problem.. By kevin - 02/26/2002 4:45:31 PM; IP 209.240.222.131 with FE oil system. It is a bottleneck that needs reworked, (bigger-smoother). As far as the 3 o'clock biz goes, the load on the cam from being driven by the chain pulling it down, stresses the 3 to 7-8 o'clock area and with the feed hole at the begining of this range, it has the most film strength possibility.

This thread, so far...

Skip Navigation Links.  FE cam bearing install -- Jon, 02/26/2002  RE: FE cam bearing install -- Bo Fabre, 02/26/2002  RE: FE cam bearing install -- Travis Miller, 02/26/2002  Three o clock is the ideal spot... -- kevin, 02/26/2002  cam bearing area -- shagg, 02/26/2002 The area behind bearing is the biggest problem.. -- kevin, 02/26/2002  RE: The area behind bearing is the biggest problem.. -- jon, 02/26/2002  Absolutely.... -- kevin, 02/26/2002

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 20248428 in the box