Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: Your right....also? By Paul G - 05/15/2002 3:28:56 PM; IP 65.105.39.2 Thanks Dave and Barry, The block will take a 14/64 in some places but will not go any higher. I am going to assume that it a decent candidate for sonic check, and not just a disposable 390. Also Dave, you mention RPM ranges in your post. I am curious, what is the max usable RPM I can expect to get from the C7AE heads. I have not posted very often, but I have been carefully reading the forum for some time. All the information I have read led me to believe that the small port heads would not flow well enough to get above 5500 with any HP gains. I would like to build the motor to maximze the capabilities of the existing components (heads & block) If there is a given max rpm the heads will flow to, Then I will select a cam based on that number. The heads have a slight cleanup on the exhaust side, but no significant porting. If the heads will support 6000-6500 rpm, then I'll work towards that. I plan to use the C6 rods with ARP fasteners and balance the rotating assembly. Aside from the block and heads, I have no limitations except that I would like it to be streetable. If being streetable means keeping it below 5500 then thats what I will shoot for. Thanks for all the great information!! Paul G. PS-Dave, the 427 blueprints are really cool. The framed copy will go nicely with the seven foot slide rule that hangs in my kitchen.

This thread, so far...

Skip Navigation Links.  Block Check -- Paul G., 05/13/2002  Sounds like a 360/390 block. -- Dave Shoe, 05/15/2002  RE: Block Check -- Barry B, 05/15/2002  Your right. -- Dave Shoe, 05/15/2002 RE: Your right....also? -- Paul G, 05/15/2002  The RPM ceiling depend on the cubes. -- Dave Shoe, 05/15/2002

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 202465022 in the box