|
|
|
|
Original Message
|
| RE: 427 MR intake vs. CJ |
| By Royce Peterson - 05/30/2002 6:10:12 PM; IP 198.81.17.176 |
All the intakes you mention are basically the same. I 1967 the Medium Riser and PI used the same intake. The CJ is slightly different in the area where the pushrods go through, just a simplification of the casting. The CJ intake is also made of cast iron.
You will notice that the port on your intake is smaller than the head vertically. Do not lower the intake port, it works great as is. If you decide to port the intake or heads it should be upward or wider.
Royce Peterson |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|