|
|
|
|
Original Message
|
| RE: Milling of intake. How much? Unknown |
| By Ray - 08/04/2002 12:52:22 PM; IP 66.81.69.218 |
| at this point, take off all gaskets and set manifold back in place, center manifold useing a feeler gauge. Then correct the height with shim stock at both ends of manifold check center again. Say there's .020 cleance at each corner, figuring you have .010 compression for gaskets, subtract .010 that number from your gaskets thickness and that should give you a good idea how much to take off manifold or heads. Ray |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|