|
|
|
|
Original Message
|
| Cylinder not firing |
| By Tim P. - 09/06/2002 9:42:38 PM; IP 68.112.191.29 |
| Just getting my bored and stroked 390 going again after a rebuild and the no. 8 is not firing. This was happening before the rebuild which led me to believe bad spark plug wire or distributor. Today I started it cold and immediately put it in gear and made it misfire/not fire for 15 seconds then I touched all the header pipes and one was noticeably cooler, so I put a new spark plug in and a new wire on and tried again with no luck. Then I pulled the hose off the vacuum advance and plugged it and tried again with no change. Is it time for a new distributor? Coil is pretty new, cap and rotor are also pretty new and look normal. I'm running the stock distributor with a Pertronix unit. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|