Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

Engine dipstick problem By James - 10/28/2002 7:51:31 AM; IP 213.219.35.122 '68 390 GT Mustang The dipstick never fitted properly, just located'on' the hole, rather than 'in' the hole. Previous owner had cable-tied it at the top. Dipstick was very bent as well, and was hard getting it in. Noticed a tapping on the dipstick, but too late, and now the end is missing! I reckon it must have been the crank? I took the pan off, and found the bit of metal - but now have no dip-stick! (It's now too short!!) I'm trying to get a replacement - how should a proper dipstick fit?? thanks James

This thread, so far...

Skip Navigation Links. Engine dipstick problem -- James, 10/28/2002  Here's where to get a new one -- Royce Peterson, 10/28/2002  Dipstick must be installed correctly & look for ID#. See related... -- Mr F, 10/28/2002

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2025122627 in the box