Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

Wrong forum, but here goes.... By John - 05/21/2003 5:53:45 PM; IP 142.177.82.31 I am pretty sure the rope seal uses a little pin protruding out of the block (upper half). The pin has to be removed to put in the neoprene seal, and of course will cause the rope seal to appear stuck. Sorry to tell you, but you have to drop the crank to do this. It's possible I remember incorrectly and the pin is in the bearing cap, so check there first. There will only be one pin regardless.

This thread, so far...

Skip Navigation Links.  stuck rope seal -- Steve, 05/20/2003 Wrong forum, but here goes.... -- John, 05/21/2003  Update -- John, 05/21/2003  RE: Update -- Steve, 05/22/2003  A wood screw? Good grief - what was the plan, there? [n/m] -- Mr F, 05/22/2003  Here's the 'right' Forum, to which John was referring... -- Mr F, 05/22/2003

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2024191841 in the box