|
|
|
|
Original Message
|
| Problem with edelbrock carb. |
| By DAVE HOLT - 07/23/2003 4:33:17 PM; IP 69.24.10.137 |
Just rebuilt my 428 pi motor
carb -new edelbrock performer
dist- new single advance
problem - set timing at best vacuum. Check with timing light and timing mark is not even close but runs fine. When i install dist. Vac line to timed port it skips badly, when i install to full vac port it quits running. Do i need a vac regulator?? suspect my balancer is cheezed but shouldnt it still run ?
help!! want to go to a show this weekend. Thanks dave. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|