|
|
Original Message
|
RE: C4AE-A 390 block |
By McQ - 10/18/2003 12:29:46 AM; IP 65.176.64.170 |
I know this thread is a few days old but I thought I'd throw in a little bit based on some knowledge I gained while working in a local engine re-building shop a few years back.
The C4AE and earlier cores were just piled up outside for scrap. During breaks I'd go out with my handy ratchet & trio of 1/2", 9/16", 7/16" sockets along with a 6" extension. It'd take just a few minutes to have a pan off. There were many C4AE 352 & 390 blocks with with the cross bolt bosses. I couldn't stand to see them get hauled away on the scrap truck so the owner would let me have them for $15 each. About what they were bringing for scrap iron at that time.
I think I still have a couple left stacked up out back in my own little treasure (one man's junk....) pile. I've never taken the time to check one of these out very closely. Someday I will. |
|
This thread, so far...
|
|
Post A Response
|
|
|
|