|
|
Original Message
|
RE: 390 problems, need help bad!! |
By lenny - 12/05/2003 9:29:10 PM; IP 152.163.252.226 |
5: sufficient voltage to coil?both start and run sides? 6: worn or misshapen dist lobes or any shaft play in dist.? 7: corect type of coil for your application 8: shorted tachometer or wired incorrectly 9: proper re-installation of dist( a couple of teeth off is a very common problem on fords with the hexagonal oil pump drive) 10:correct alignment of timing set 11: didyou install the pin in the front of the cam when you put it all together? 12:correct firing order? |
|
This thread, so far...
|
|
Post A Response
|
|
|
|