Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: Here ya go. By Tim P. - 01/26/2004 12:17:55 PM; IP 152.163.252.228 Dave I Measured The Block Cyl. Thickness They All Came Out At 13/64ths Except On The To Center Cyl. on both sides they were 14/64ths near the tops only this is a casting # C7ME-A 4.05 orginal bore how far can this be bored roughly guessing and who does sonic mapping any input appreciated, Thanks Tim.

This thread, so far...

Skip Navigation Links.  Cyl Wall Thickness Test -- Tim P., 01/08/2004  Here ya go. -- Dave Shoe, 01/08/2004  RE: Here ya go. -- BarryMcLarty, 01/08/2004  It'd work, but I prefer drill bits. -- Dave Shoe, 01/08/2004  RE: Here ya go. -- Tim P., 01/08/2004  RE: Here ya go. -- BarryMcLarty, 01/08/2004  Actually, my purpose is a bit different than some. -- Dave Shoe, 01/08/2004  RE: Actually, my purpose is a bit different than some. -- Paul Garvin, 01/09/2004  Wall thickness -- Steve M, 01/12/2004  RE: Actually, my purpose is a bit different than some. -- bear, 01/17/2004  Here are a couple of references. -- Dave Shoe, 01/27/2004 RE: Here ya go. -- Tim P., 01/26/2004  RE: Here ya go. -- Tim P., 01/29/2004  Sounds like a nice block. -- Dave Shoe, 01/29/2004  RE: Sounds like a nice block. -- Tim P., 01/29/2004  The "X" remains a mystery. -- Dave Shoe, 01/30/2004  RE: The "X" remains a mystery. -- Tim P., 01/30/2004

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2024131910 in the box