|
|
|
|
Original Message
|
| RE: casting number |
| By fordlover - 02/15/2004 9:51:40 PM; IP 216.228.55.218 |
| what do you mean by oil relief? a small soft plug up by the cam plug? will look at motor tomorrow and try to give you more infor on other questions by if memory serves me right I beleive that it only has 2 motor bolt holes My next question is if it is a 352 can I bore it to a 390 I see on this site a hot rod build that puts out 450 hp at 5600 and 460 lb ft at 3900 rpm would this be possible using a 352 block? One last question this build says the cam has a222/228 degrees of duration at 0.050 and 0.584/0.604 lift. how radical is this would i still have enough vacuum to run power brakes and would it idle with a/c thank you very much for your time this form has been more help than I have found any where else thank you again R.J. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|