|
|
|
|
Original Message
|
| RE: oil pump shaft in oil pan |
| By Davy Gurley - 03/02/2004 6:50:29 PM; IP 69.6.135.147 |
| I agree with Paul, put in a new one and go. You'll have to knock off that little washer before you can install it from the top. I've been known to put some yellow 3m on the distributer end of the shaft and glue it in, then it sure won't fall out next time. Be sure you put a spot of grease on the pilot and the bottom of the gear before you install it. It's no fun when the dizzy shaft galls to the block. I would recommend that you turn the engine over a few times by hand and make sure it doesn't bind up on the dropped shaft. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|