|
|
Original Message
|
RE: No, it will not work, for several reasons, |
By Don F - 04/18/2004 11:43:09 PM; IP 216.180.4.253 |
I knew it would not just bolt in.I figured if the input shaft and collar are the right length then it might work.The pilot bushing and clutch I don't think are a big problem to overcome.I have seen B&B style clutches sold for Fords in the past. The trans should be centered if the input shaft was in the pilot bearing.But, it may be more trouble than its worth. |
|
This thread, so far...
|
|
Post A Response
|
|
|
|