|
|
Original Message
|
RE: Oil Pump Knock? |
By David - 05/19/2004 5:02:32 PM; IP 69.48.12.202 |
Tony sorry to hear about your cam. Check to make sure that your cam bearings were/are installed properly so that the openings in the bearings align with the oil passages in the block. Also make sure the front (#1) cam bearing has the 2 holes aligned with the oil passages in the block & the passage from the one opening on the berring is running to the front of the block to lube the thrust plate or needle bearing setup if you installed one. If you have that oil passage on the brearing faceing the back of the block you will have a oil pressure drop/leak. Which could cause oil starvation. Good luck & keep us posted. |
|
This thread, so far...
|
|
Post A Response
|
|
|
|