|
|
|
|
Original Message
|
| motor mounts |
| By Dale Cecil - 06/26/2004 12:17:44 AM; IP 63.231.104.247 |
I have searched the archives, and none of the posts seems to be specific to my question. I am getting ready to install my engine in my car. It is a 1964 390 block going into a 68 Mustang. The 64 block has only 2 mounting holes in it. It was previously in the car with some homemade custom solid motor mounts.
My question is this. Can I get the original style mounts with the rubber insulators and modify them to bolt up to my block? My frame section is still in stock configuration as the previous solid mounts were made to fit the existing holes.
What all pieces would I need, and what kind of fabrication would be necessary?
I looked at the Total Control website, and they have a nice set of mounts, but the holes look to run horizontal, and my two holes are situated vertically.
Again, thanks for your help.
Dale
|
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|