|
|
|
|
Original Message
|
| RE: Brake help |
| By raycfe - 07/17/2004 9:20:56 PM; IP 207.69.137.200 |
| Bleeding the light is on because the switch in the block has been pushed off center. I would dump the Dot 5, but you have to flush it real good. Dot 4 is all you need. Bleeding in a jar is almost a must. After the bleeding is all done the lite is reset by having a helper push real hard on the pedal and watch the lite. You open a rear bleeder as little a possible and close it as soon as the lite goes out, if it doesn't repeat on front. You would get more help if you posted in the other (-FE) forum. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|