|
|
Original Message
|
It's probably OK for a 352 / 360 application. |
By Royce Peterson - 03/04/2005 3:12:30 PM; IP 66.161.209.2 |
I don't have anything smaller than 430 cubic inches so I need intake manifolds with runners bigger than the end of my thumb. All my heads are eithe Cobra Jet or Edelbrock with a port much larger than the Streetmaster's. But on a small inch motor like a 360 or a 352 it is probably the right manifold. Particularly if outfitted with late FE emissions type heads like the C8AE-H or D2TE-A.
The Streetmaster was designed during the 1970's gas crunch when everyone was panicking about 75 cent a gallon gas. I believe it was rated from idle to 5000 RPM as the recommended operating range. It slowed down a GT 390 Mustang I used to have. A Performer RPM was significantly better on that engine.
Royce |
|
This thread, so far...
|
|
Post A Response
|
|
|
|