|
|
|
|
Original Message
|
| 9" axle runout? |
| By Geoff McNew - 08/07/2005 2:34:05 AM; IP 66.42.13.108 |
So, none of my Ford manuals have a spec on this....all it gives are center section & pinion dims///
What sorta maximum run out for an axle shaft is OK?........it translates to rear tire wobble.
In other words, when I pull the brake drum and run a dial against the wheel flange mounting surface, just outside the studs....and I'm looking to see if it's the wheel or the axle that's out...what should I see?
is 0.004"...0.007".....is that OK?
.....keep in mind, I'm not running Talladega. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|