|
|
|
|
Original Message
|
| C4AE-G heads and 2.09 & 1.65 valves? |
| By KSKI - 08/28/2005 8:42:43 PM; IP 65.166.115.44 |
I just can't stop checking out this awesome forum. You guys really know your FE's in and out! Here goes a whole lot of questions!
I've got C4AE-G heads and would like to have 2.09 & 1.65 valves put in, than port & polish the heads for better flow. Is this valve change possible with these heads, and would it be worth my effort, power wise?
How close will C4AE-G intake ports match up to the Performer RPM intake manifold ports, I will most likely port match them, just asking?
My engine is a 390, .030" over, I'm pretty sure the larger valves should clear the deck of the block with .544" valve lift, and I'd still would like to stay with my non-adjustable rocker setup, is this possible to stay non-adjustable rockers with a .544" lift hydraulic cam?
Back to the non-adjustable rockers, what are these stronger rocker end stands you guys are always talking about, and where do you buy them? And should I stay with the rocker stand bolts, or buy a stud and nut set up?
That about does it, THANKS for your replys ! |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|