|
|
|
|
Original Message
|
| RE: Crank and flywheel/flexplate, right |
| By john h - 01/22/2001 12:48:49 AM; IP 172.161.131.155 |
yes i know that the 428 was externaly balanced. as for the roller im looking at the Comp Cams K337818. the K kit includes cam, lifters, matched valve springs, retainers, locks, seals, timing set, and lube, itll run you about $750. http://www.competitioncams.com/catalog/176_177.html#Anchor
With the rollers you'll need to be sure to have hardened rocker shafts
(available from Harland Sharp) and billet stands. The spring pressures are
more than the cast stands can handle.
If you are using the edlebrock heads make sure you go with bare castings and use the springs specified by comp cams. edlebrock said that theirs wont hold up with this type of cam.
> They are not good with a mechanical roller.
> You will need to change the springs to the cam companies recommended
> spring
> set up.
> Sent: Wednesday, December 27, 2000 8:31 AM
> To: edelbrock@edelbrock.com
> Subject: Edelbrock 6006 heads
|
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|