|
|
|
|
Original Message
|
| Edelbrock Al Heads and Intake |
| By david kiser - 04/17/2001 5:04:19 PM; IP 143.209.20.223 |
| I'm close to assembling my 428. I've purchased Edel. 6006 heads, Edel. Head bolts and an Edel. RPM intake, but they haven't come yet. This is my first experience with Al. heads and have a few questions. Do I stick with the factory Torque recommendations for head bolts and rocker stand bolts? Are Fel Pro gaskets (standard type) OK for heads and intake? Do I need shorter than stock Bolts for the rocker stands, I've heard that these heads are not tapped as deep. Do I need to run some stop-leak in the coolant due to porosity of the Aluminum? Do I use the stock baffles? Are the oil passages restricted as Made by Edelbrock, or will I need to put in a restrictor (.100" ?). I know some of these questions will be obvious when I get the parts, but I'm just gathering info. now. Any other info. or input is greatly appreciated. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|