|
|
|
|
Original Message
|
| RE: Edelbrock Al Heads and Intake |
| By ANDY - 04/17/2001 11:21:57 PM; IP 203.56.239.116 |
| As you said these questions will be answered when you get the goods as they come with an info sheet with recomended gaskets and bolt torques. From memory I think you do have to cut down the long bolt for the shaft stands. Some simple mods and the standard drip tray fits fine (I think there are at least two styles of drip tray, one fits easier than the other). I put a bottle of Moroso ceramic block liner (cant remember what its really called) in just to try and keep the coolant off the aluminium, 3 years later no worries. Personally I dont like restricting the rockers to much and run the passages unrestricted as they are smaller than the original ones. I also run restrictors next to the rockers (in the form of close tolerance washers) to control oil bleed off out the side of the rockers after the oil has done its job. I wasnt overly impressed with valve job (valve stem heights all over the place) but installed them anyway as impatience (and my wallet) got the better of me. Good Luck. Have Fun. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|