|
|
|
|
Original Message
|
| Aftermarket intake vs. stock |
| By Boyd - 11/10/2001 12:29:24 PM; IP 63.10.181.147 |
| I'm getting ready to put my '67 410cid Merc back together and I have to replace the cam and lifters. The block was bored 30 over and I am using cast pistons. I am also using the stock heads. I plan on buying an Edelbrock cam & lifters. I'm not going to the drag strip but I want to get a little more power out of the engine. I was wondering if there would be any advantage of getting a performer intake over using the stock cast iron intake (besides the weight difference). I also plan on using a Holley 750cfm carb. Would that be too much? Any help or comments appreciated. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|