|
|
|
|
Original Message
|
| Bellhousing questions |
| By Paul M - 11/20/2001 5:18:15 PM; IP 24.20.44.11 |
Anyone know this casting # off a bellhousing, from prior experience, or from one sitting in the garage? # is C5AA-6394-A, and it's supposed to be out of a 390 car. It has the z-bar mount on it, rather than on the engine block, like my truck. It also has the flat, spring-steel style mount for the release fork.
Reason I ask is, my truck has the wire clip style fork, and the mount shattered, leaving me with no clutch. I want to change over to the other style, and this bellhousing is close and affordable, and I don't have to pull it!
I havent pulled my tranny yet, so I can't lay them side by side to compare, (to much rain) and I need to know if it will be compatable, ie; release fork location in particular, but length from engine block to tranny as well.
The bolt pattern for the trans is the bigger style, with the bosses for a smaller pattern cast-in.
Any thoughts?
|
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|