|
|
Original Message
|
RE: Can someone identify these numbers or... |
By Jim - 12/02/2001 5:16:46 PM; IP 165.121.115.144 |
Hey Robbie,
You are right...the intake is C7ZX-9425-A for sure.
What can you tell me about it? Is there a known RPM range for this intake? What did it come on? What carbs came stock on it? Is there a casting date code on it somewhere?.............
The C7EA-A date codes 6K21/6H11 have smog holes.
These are the original heads of of my '67 390 GTA Mustang
Aren't they 390 GT heads though? What designates 390 GT heads?............
Hmmm,so the C3AE-D are 427 low riser heads? What is the size of the combustion chambers on the C3AE D heads? What is the difference between low, medium, and high riser heads? Is it just the combustion chamber sizes and/or valve sizes?
I think you are right again that I DO NOT have a CJ block :()....
it is definately C6ME-A date code 6L4, It has a "Y" webbing and not the "W" looking webbing on the main supports. The main caps have 1C 2AE on them. There is 3 (lifter galley?) holes above the cam hole on the back and one below it but I dont see any threads in the holes. Tha 2 inch "A" on the back looks like it was scratched into the sand and not welded and there is a 3/8 inch 26 above a 3/8 inch 352. The upper left front of the block has a 1/4 inch 20 above a 3/8 inch 352 and there is an upside 1/4 inch upside down stamped 72S....Okay, Im sitting down...tell me if it is a CJ or not....Oh well, I am not a CJ owner :(....Most likely it is a PI block then becuase I got it from a Cop in the mid 70's unless the PI blocks ONLY have "W" webbing on the mains. Would that mean that it is just a standard 428 block?.......
Thanks Robbie
..
|
|
This thread, so far...
|
|
Post A Response
|
|
|
|