|
|
|
|
Original Message
|
| RE: 66 cyclone p/s brackets |
| By Gerry Proctor - 01/02/2002 7:13:25 AM; IP 208.217.67.246 |
| The correct brackets aren't that hard to come by, Blake. They're on Ebay all the time. I can't tell you all of the possible vehicle targets, but I recently purchased a p/s pump with the bracket and this one happened to come of a Mustang Cleveland engine. While the pulley itself won't work, I was surprised to find that the pump bracket was dimensionally identicle to my factory '67 Fairlane aluminum even though it was made of pressed steel rather than cast aluminum. I would look at any of the big block intermediate unibody and at least the Cleveland Mustang platforms. You'll also need the triangular steel bracket that mounts to the water pump. Again, I see these all the time on Ebay and just a note...there is no difference between a common 390 two-barrel p/s bracket assembly or a 428 Cobra Jet assembly. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|