|
|
|
|
Original Message
|
| I found my "ticka tacka ticka" noise. |
| By James - 03/10/2002 10:43:35 PM; IP 64.12.96.105 |
| My Lunati cam went round. I didn't have all the parts here yet but I couldn't stand it any longer. I tore into that sucker with a vengence. The forth lifter from the front on the driver's side was all chewed up. The lobe right across from it had been affected by all the shavings. The reason it didn't pop back through the carb is that it was on the exhaust side. The .514 lift 224 duration cam is the most popular hydrolic grind that Lunati makes for this engine family and it has been around for 8 years or more with a long history of no failures. Summit selles out of it regularly so I was just one of the lucky ones. If a cam is going to go round it will usually do it at break in not at 6000 miles according to the people at Lunati. I posted about the tick earlier this week and I was asked to post my findings so there you go, round cam. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|