|
|
Original Message
|
RE: extreme heat |
By Bob - 04/20/2002 6:57:01 PM; IP 65.80.204.131 |
0.060 or even 0.090 is too thin in my opinion and the cause of your problem.
I have done the following to a running engine to pin the problem down. I installed a electronic temperature gauge, rotatary switch and several sending units. The gauge could be connected to any of the sending units via the switch. I had sending units at the water pump inlet at the bottom radiator hose, the back of the block down by the culinders on the drivers side, at the front of the manifold behind the thermostat, and in front of the thermostat by the upper radiator hose. |
|
This thread, so far...
|
|
Post A Response
|
|
|
|