Home
Free Stuff
Graphics
Programming Services
Contact Us
Ford Stuff
Skip Navigation Links
Setup
New Post
Search
Forum Home
Home
Decoder
Original Message
RE: Zinc will work too!
By Bob
- 05/04/2002 4:24:39 PM; IP 65.80.205.69
Pre-heat the head? how hot? Could zinnc be used to build up the floor on the intake and or exhaust ports?
This thread, so far...
Skip Navigation Links.
390 Project
--
Ted Young,
04/30/2002
Cast iron is relatively easy to drill.
--
Dave Shoe,
04/30/2002
Is a C4SE intake a better choice?
--
Ted Young,
05/01/2002
Stick to the Edelbrock.
--
Dave Shoe,
05/01/2002
RE: Edelbrock/Heat Crossover
--
Mike McQuesten,
05/02/2002
68 390cid and 428cid parts interchangeability
--
kenny brown,
05/02/2002
RE: 68 390cid and 428cid parts interchangeability
--
Gerry Proctor,
05/03/2002
390 flywheels are easily offset balanced.
--
Dave Shoe,
05/03/2002
I run my blocked crossovers in Minneapolis.
--
Dave Shoe,
05/03/2002
RE: I run my blocked crossovers in Minneapolis.
--
salid,
05/03/2002
RE: Zinc will work too!
--
Ray,
05/04/2002
RE: Zinc will work too!
--
Bob,
05/04/2002
RE: Zinc will work too!
--
Ray Tirri,
05/04/2002
RE: Zinc will work too!
--
Bob,
05/04/2002
RE: Zinc will work too!
--
Ray,
05/04/2002
Tri-Power.
--
KEN BARNES,
05/04/2002
Shoe, please take a look at my 427 sonic map
--
Josh,
05/05/2002
Post A Response
Subcribe
Name:
Email Address:
Subject:
Post:
Upload Image:
Human Check:
Enter the code 202493359 in the box