Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

Technically: Yes. By Dave Shoe - 06/04/2002 4:22:08 PM; IP 12.2.11.131 Actually, I'd prefer to make a head mod before installing them. The Ed head comes with MR-sized port face. The tri-power intake obviously has the taller LR-sized port face. They will seal fine, but the mismatch is not exactly ideal, since gasoline could technically puddle a bit at the step (maybe it does, maybe I'm just imagining it), and the lower plane of the intake may crave a little more access to the head. Since the Ed head is cast to be easily converted to a LR port-face size by chamfering the outermost portion of the head's runner, it would be IDEAL to open the Ed head's floor up to match the intake manifold's port. You'll have to decide whether carving on the heads this little bit is what you want to do. I suspect I would, if put in the same position. Shoe.

This thread, so far...

Skip Navigation Links.  Oh FE gurus, I need a answer... -- Dan Davis, 06/03/2002  For looks, nothing beats the 'M-series' set-up... -- Mr F, 06/03/2002  I'm with Mr. F on this. -- Dave Shoe, 06/04/2002  And they fit with E-brock heads, right? [n/m] -- Dan Davis, 06/04/2002 Technically: Yes. -- Dave Shoe, 06/04/2002  Awsome. Thanks Dave & Mr F. [n/m] -- Dan Davis, 06/04/2002  And I must agree with Dave - match 'em. [n/m] -- Mr F, 06/04/2002

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 202472656 in the box