|
|
|
|
Original Message
|
| RE: FE to AOD |
| By salid - 07/21/2002 7:51:30 PM; IP 208.186.86.97 |
| try http://www.lentechautomatics.com/. Lentech builds an AOD for the FE. They may be willing to sell you the correctly cut front section to bolt to your AOD, but you would have to take it to a machinist to get the front cut off the AOD and then drill it for the bolts. If you don't already have "THE" AOD built, you'd probably be better off to just get the Lentech. They are spendy, and Lentech says that OD is only good for 400 ftlbs of torque. Any strong FE will be making 400 lbs just about anytime the secondaries are open. That fact has kept me looking for a better way. Maybe a GearVendor OD, any one out there with any experience on these? |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|