|
|
|
|
Original Message
|
| Overheating |
| By Dave - 07/24/2002 3:20:51 PM; IP 152.163.197.178 |
| My 428 in my 67 Mustang is running pretty hot. It has an edelbrock water pump, 180 thermostat, March pulleys for a FE, new Modine 3 core with stock fan shroud. The shroud does not come very far over the fan. Do I need to shim the shroud. Less then half the fan is inside the shroud. Has anyone run into heating problems with the March pulleys? The carb is a Holley that is pretty rich. 80primary 83 secondary 5.5 on the pump. Engine has a pretty mild cam. Ford A411, Edelbrock Performer RPM Intake. Temp is running up to 220 after running for a while on city streets. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|