Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: Milling of intake. How much? Unknown By Terry - 08/06/2002 11:49:40 PM; IP 63.161.101.213 OK here is what I did and correct me if I'm wrong. I put the gaskets on the heads and sat the intake on without the bottom gaskets. I than measured the the distance at all 4 corners at bottom and came up with .088 and I then subtracted this from .170 the thickness of the bottom gaskets and came up with .082 After looking at the Steve Christ book I thought .078 needs to be removed from the bottom and .055 from each side to be on the safe side. Did I figure right? Thanks for the help Ray and give me the OK before I take the manifold to the shop. Thanks!

This thread, so far...

Skip Navigation Links.  Milling of intake. How much? -- Terry Good, 08/03/2002  Sounds like the block might have been milled N/M. -- Royce Peterson, 08/04/2002  RE: Milling of intake. How much? Unknown -- Ray, 08/04/2002 RE: Milling of intake. How much? Unknown -- Terry, 08/06/2002  RE: Milling of intake. Maybe not! -- Ray Tirri, 08/07/2002  RE: Milling of intake. How much? -- RCV, 08/06/2002

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 202472626 in the box