|
|
|
|
Original Message
|
| RE: Need info- 5 speed truck trans behind FE block |
| By Davy Gurley - 08/19/2002 10:32:17 PM; IP 209.40.144.223 |
| I installed a NV4500 out of a Dodge pu in my 72 F-250. You need and adapter from Advance Adapters to bolt the tranny to your bell housing. I had to make a pilot bushing to fit the tranny and I used a clutch plate for an International!? truck. It had the correct splines on it. You will have to modify the hole in the floor for the shifter but dodge has a huge boot that will cover it and look good. You will have to make your own rear crossmember and shorten your driveshaft. My pickup was a 4x4 so I didn't have to deal with a speedo and I can't help you with that. You will like this conversion. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|