|
|
|
|
Original Message
|
| RE: cam spacer, cam gear bushing |
| By Charlie - 09/10/2002 2:17:34 PM; IP 12.252.228.242 |
In later than 63? 64? ford stopped using the split ring cam spacer, and machined it into the timing gear itself. I'd say your diagram is either an older one or probally has 2 versions of the cam asssm. in one picture. This is all assumeing your engine has a cam retension plate?
I'm not sure about the bushing your asking about. On the last 390 we built there wasn't any. Make sure you check for cam play regaurdless should be .07 or less I believe.
Hang in there and someone from here will finish answering your questions, There is some sharp fellas on this site.
Charlie |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|