|
|
|
|
Original Message
|
| RE: Scew in Freeze plugs how do i install? |
| By Martin - 09/10/2002 5:44:45 PM; IP 66.135.226.87 |
| Earlier this year they ran an article series in "Mustang and Fords" where they had Rousch Racing (Spelling ?) build a 390 for the 21st century. They mentioned that they had the machinist tap the holes for the freeze plugs when the engine block was done. In the article brass plugs were then screwed in with an epoxy as a sealer. I don't think there were any pics of the process itself. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|