Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: If early 60s it's a plain 390, later a 428 or 361. By Rollie H. - 09/29/2002 1:31:47 PM; IP 199.183.169.218 I checked between the cylinders with different drill bits and the largest size I can fit between them is 5/32. Of course there may be some build up in there so after it is all cleaned up it will likely be more like a 3/16 to 7/32 bit will fit. I absolutely can't force a 15/64 bit in there. There is no doubt that even after a clean up the results will be the same with the 15/64 drill bit. I think he wants to sleeve just one cylinder to keep from having to change all eight pistons. That cylinder had a piston go bad and it scuffed the cylinder some. You can feel the damage with your fingernail, so it is time to bore it out not sleeve it. I think he is making a mistake since this will weaken the block in my opinion. Thanks for the help and tips!

This thread, so far...

Skip Navigation Links.  "C Scratch Block" Question -- Rollie H., 09/29/2002  If early 60s it's a plain 390, later a 428 or 361. -- Dave Shoe, 09/29/2002 RE: If early 60s it's a plain 390, later a 428 or 361. -- Rollie H., 09/29/2002  If he want's to be cheap... -- Dave Shoe, 09/29/2002  Sleeving -- John, 09/29/2002  RE: Sleeving -- Rollie H., 10/01/2002

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 202455557 in the box