Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: Lots of new on 390...still some problems By Ron D. - 10/02/2002 10:05:14 PM; IP 207.49.215.126 Darel: Something just doesn't sound right, You Should notice an improvement with what you've done. I suggest that you recheck your firing order, It's too easy to get it wrong. Also, remember that the settings in the book are there to get the thing running, not necessarily running the best possible, a little change in timing, advance curve, pump shot etc., etc. can help dial in your combination. You might want to check the "play" in your timing chain too! With engine off, remove the distributor cap and turn engine over by hand until rotor moves, then reverse direction until rotor moves again. There should not be much movement, if there is a lot of movement, then it's time to replace the timing chain. JMO, Ron

This thread, so far...

Skip Navigation Links.  Lots of new on 390...still some problems -- Darel, 10/02/2002  I think the plug gap is too wide. N/M -- Royce Peterson, 10/02/2002  possibly, but......... -- Pete, 10/02/2002  RE: possibly, but......... -- Ryan, 10/04/2002  RE: possibly, but......... -- Pete, 10/04/2002  RE: Lots of new on 390...still some problems -- Neil, 10/02/2002 RE: Lots of new on 390...still some problems -- Ron D., 10/02/2002  Got some help... -- Darel, 10/03/2002

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 202452455 in the box