|
|
|
|
Original Message
|
| Off setting the boring means.... |
| By Just Strokin - 10/04/2002 2:20:26 PM; IP 208.62.208.135 |
you are shifting the boring bar in relation to the center of the current bore to give you safe cylinder wall thickness in all directions. It may only be shifted a few thousandths or may be shifted a few hundreths. This shift will not normally affect any alignment that the current clearances can't take care of during engine operation.
This shift takes into consideration how much you are going to 'over' bore the block from std bore size. |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|