Forum Reply - JCO Consulting Services


Home	Free Stuff	Graphics	Programming Services	Contact Us	Ford Stuff

Original Message

RE: Are you sure it's blowby?

By BEAR - 12/11/2002 8:20:16 PM; IP 141.151.153.126

when putting the piston in the cylinders did you coat them oil and if so did you use synthetic. this some times causes blow by on fresh motors. If not then i would do a leak done and\or a compression check. However, if you did not use restrictors in the heads and a high volume oil pump you could be filling the valve covers with oil. I cut a set of valve covers down the middle about and inch wide and let the car run. done rev it a lot or you will be cleaning oil up everywhere. Hope that helps.

This thread, so far...

Skip Navigation Links.

Collapse <a href=../ForumFE/reply.aspx?ID=15590&Reply=15590><img src=../images/reply.png width=30 height=10></a> <a href="#" id="anchor15590" onclick="return false;">blowby</a> -- <font color=#0000ff>jason, <i>12/11/2002</i></font><script type="text/javascript">
new HelpBalloon({
dataURL: 'replyb.aspx?ID=15590',
contentMargin: 60,
icon: $('anchor15590')
});
</script>

blowby -- jason, 12/11/2002

Collapse <a href=../ForumFE/reply.aspx?ID=15593&Reply=15590><img src=../images/reply.png width=30 height=10></a> <a href="#" id="anchor15593" onclick="return false;">Are you running a PCV system?</a> -- <font color=#0000ff>Royce Peterson, <i>12/11/2002</i></font><script type="text/javascript">
new HelpBalloon({
dataURL: 'replyb.aspx?ID=15593',
contentMargin: 60,
icon: $('anchor15593')
});
</script>

Are you running a PCV system? -- Royce Peterson, 12/11/2002

RE: Are you running a PCV system? -- jason, 12/11/2002

Collapse <a href=../ForumFE/reply.aspx?ID=15611&Reply=15590><img src=../images/reply.png width=30 height=10></a> <a href="#" id="anchor15611" onclick="return false;">Did you use file fit rings? What is the ring gap?</a> -- <font color=#0000ff>Royce Peterson, <i>12/11/2002</i></font><script type="text/javascript">
new HelpBalloon({
dataURL: 'replyb.aspx?ID=15611',
contentMargin: 60,
icon: $('anchor15611')
});
</script>

Did you use file fit rings? What is the ring gap? -- Royce Peterson, 12/11/2002

RE: Did you use file fit rings? What is the ring gap? -- jason, 12/11/2002

Collapse <a href=../ForumFE/reply.aspx?ID=15615&Reply=15590><img src=../images/reply.png width=30 height=10></a> <a href="#" id="anchor15615" onclick="return false;">Are you sure it's blowby?</a> -- <font color=#0000ff>John, <i>12/11/2002</i></font><script type="text/javascript">
new HelpBalloon({
dataURL: 'replyb.aspx?ID=15615',
contentMargin: 60,
icon: $('anchor15615')
});
</script>

Are you sure it's blowby? -- John, 12/11/2002

RE: Are you sure it's blowby? -- BEAR, 12/11/2002