|
|
|
|
Original Message
|
| re; new questions on 390 rebuild |
| By David - 01/02/2003 10:23:47 PM; IP 216.114.21.56 |
| Now that I have my oil filter/pump problem taken care of I want to pick your brains on a couple of other things. The motor is in a old chasis, one that I can not drive. I have it in there while I do body work on its final home. I wanted to do this so I could run it from time to time, is there anything given these circumstances I should be doing as far as break-in. Also I have a slight spuratic lifter noise. I am assuming I need to adjust the valve lash on a couple be either shortening or lengthening the push rods where needed and it will go away? Also I posted in the general forum about restoring the bottom of my chasis. I was hoping to get more input, should I sand blast, wire brush, or what have you fellas out there all done? I think I will undercoat the whole thing, would this be proper? |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|