|
|
|
|
Original Message
|
| RE: Lightning bolt chrome valve covers |
| By McQ - 02/18/2003 9:42:46 PM; IP 63.191.224.208 |
I also ran a set of these years ago on a '66 Cyclone GT but I had to have mine chromed. I ran two driver's side(L) so that I was able to run twist in breathers in both covers and a PSE aluminum breather on the back of the C7 PI intake all on top of a 428CJ. It was a great car that easily would ran 13.5s/103 mph on an old set of Mickey Thompson 7" wide 14" slicks. Drive it to the strip with the slicks/wheels in the trunk. Jack it up and make the quick switch. Nice all around driver.
I like the Mercury v-covers a lot too. I currently have a set on the 390 in my '68 F100. Again, two drivers allowing twist in breathers. I think I have four passenger side stored in the back of a '67 Merc wagon, which require a grommet for the push in PCV valve extra....... |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|