|
|
|
|
Original Message
|
| pushrod length for roller rockers? |
| By Geoff McNew - 03/03/2003 3:38:33 PM; IP 66.52.140.104 |
| My understanding of correct roller to valve tip geometry is that, at full lift, the roller should be centered on the stem - & not nearer the valley nor having rolled past center. The thinking is that at full lift is where maximum spring pressure is encountered and by centering the roller at this point you minimize the side loading and deflecion. Is there agreement out there? |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|