Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

Intake By John - 03/28/2003 5:36:19 PM; IP 67.119.118.41 I need some help deciphering the following casting number...C3AE-9425-K Its a 2X4 Aluminum MR intake(I'm assuming MR since it does fit CJ and 427MR heads) The killer is the K. I have looked at all my Ford FE engine books and material and could not come up with a match. Could it be a special production?? Any help would be greatly appreciated....Thanks in advance...John P.S. Whats also interesting about the K is that it is stamped in opposed to being a cast number. I checked with a magnifing glass and no number was ground off underneath it...the cast numbers actually stopped after the 5 then a dash and the K was then stamped on.

This thread, so far...

Skip Navigation Links. Intake -- John, 03/28/2003  Should be a 427 LR 8v intake. [n/m] -- Mr F, 03/28/2003  RE: Should be a 427 LR 8v intake. [n/m] -- John, 03/28/2003  It's a later revision. -- Royce Peterson, 03/29/2003  A new 'suffix' indicates revised machining or casting fixture(s). [n/m] -- Mr F, 03/29/2003  Yup, it's a 427 Low Riser. -- Royce Peterson, 03/28/2003

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2024233559 in the box