|
|
|
|
Original Message
|
| RE: 67mustang motor |
| By Gary Adam - 04/09/2003 7:14:30 PM; IP 142.179.250.208 |
Carlos, -- port matching is always a good idea
when it comes to better performance (as in better flow).A really bad port match opened up
to good port match would help - but I'm not so
sure you would actually feel it in the seat of your pants. But couple that with a good porting
job and you'd definitely feel it. More in the higher rpm range than down low. But I have
not done any porting to these heads, so check
the search button for any info in that regard. I
do know these head need all the help they can
get and respond well when done right. Also check about larger valves. I'm going to go with
the Edelbrock heads myself -- bigger valves,
good ports, alot lighter in weight, better heat
dissipation, etc. Some say a prof. port job with
bigger valves will run you close to the same or
maybe even more money than Edel heads do.
So be check out costs carefully. Good luck! |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|