|
|
|
|
Original Message
|
| Are Edlebrocks heads that much better |
| By Mike - 04/16/2003 7:53:48 PM; IP 68.103.59.112 |
| I have a 69 mach 1 that has a stock 428 cj in it. I am going to pull it and put it on the stand and put a built 428 in it. I have some C6AE-R's that i would run. I am just wondering i assume it would probably cost me close to 400-500 bucks or so to get them rebuilt with new seats and cut for cj valves. I do have some new Cj valves so i am just wondering instead of spending that much to rebuild C6AE-R's should i just go with some edlebrocks. They are only 450 a piece bare, I get more hp, can handle higher compression easier,and since i have valves all i will need is to lap the valves right? They are lighter too. Do the edlebrocks flow that much better? |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|