|
|
|
|
Original Message
|
| RE: Big spline and small spline are different parts. |
| By Mike Drew - 06/30/2003 4:59:09 PM; IP 168.187.1.11 |
> The best I can tell, big input shaft (1-3/8") clutch and pressure plates
> are different than standard input shaft (1-1/16") clutch and pressure plates.
>I can understand that there are two different discs (to accomodate the different sized input shafts), but why would the pressure plates be different?
>
> The long-style fingers are designed for either the large style or else
> small style throw out bearing, and the hole in the pressure plate is sized
> accordingly, too.
>
> There may be some commonality with aftermarket goodies, but factory stock
> clutch and pressure plates won't interchange between the large 427 input
> shaft and the standard 390 input shaft.
>Hmm. Is the standard 390 input shaft a SMALL input shaft? My wide-ratio top loader is a 390 Fairlane gearbox, HEHCM is the code (I think--memory rusty). So, my clutch is a 390 clutch, which would work on his 390. :>) |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|
|